Option Board SDI I/O v2

Option Board SDI I/O (O_DAP_SDI_b)

Standards

Video Data Rate

Video Formats

Video Delay

Audio

Metadata (RDD6)

BNC Input

BNC Output

Latency

General Features

SDI Card Self-Test

The SDI card provides a built-in self-test for verifying the SDI signal path in all three supported physical signal formats: SD, HD, and 3G.

The exact video resolution or frame rate is not important for this test. One valid signal format from each of the three categories is sufficient.

Test Setup

  1. Connect the SDI output back to the SDI input using a suitable cable to create a loop-through connection.
  2. Enable the SDI generator.
  3. Set the generator output to Black.
  4. Enable Delay and set to a value greater than 0.

Running the Test

Perform the test once for each of the following signal formats:

  1. SD
  2. HD
  3. 3G

For each format:

  1. Select any valid video format within the required SDI category.
  2. Wait while the self-test runs.
  3. Observe the status LED.
  4. Wait until the test has completed successfully before changing to the next signal format.

Each individual test takes approximately 30 seconds.

Note - The exact video resolution or frame rate does not matter. The self-test only requires one successful test in each physical SDI format: SD, HD, and 3G.

If a test does not complete successfully, it is automatically restarted and continues to run until the test passes.

LED Indication

Note - The self-test status LED is located on the SDI card between the two BNC connectors. The LED is not visible from outside the unit and can only be observed with the device cover removed.

Warning - Opening the device enclosure is at the user's own risk. Take appropriate precautions when operating the unit with the cover removed and avoid contact with internal components.

LED Status Meaning
Fast flashing blue A self-test is currently running.
Slow flashing blue The self-test sequence is incomplete. At least one of the SD, HD, or 3G tests has not yet been completed successfully.
Solid blue All three tests — SD, HD, and 3G — have completed successfully.

Important - Do not proceed to the next signal format until the current test has completed successfully and the LED indication has stabilized.


Revision #4
Created 2026-11-13 12:09:15 UTC by FK
Updated 2026-11-13 12:18:14 UTC by FK