Option Board SDI I/O v2
Option Board SDI I/O (O_DAP_SDI_a)O_DAP_SDI_b)
Standards
Video complies with SMPTE 424/425M (3G, Level A and B), SMPTE 292M (HD), or SMPTE 259M (SD)
Automatic format detection
Audio embedding and de-embedding complies with SMPTE 299M (3G, HD) or SMPTE 272M -AC (SD)
Metadata embedding and de-embedding complies with SMPTE 2020-2
Video Data Rate
2970/296Mbps (3G), 1485/1483.5Mbps (HD), 270Mbps (SD
Video Formats
1080p - 23.975, 24, 25, 29.97, 30, 50, 59.94, 60
1080i - 50, 59.94, 60
720p - 23.975, 24, 25, 29.97, 30, 50, 59.94, 60
625i - 50
525i - 59.94
Video Delay
User selectable 0 ...
1550 frames, can be disabled
Audio
24-bit, transparent forwarding of PCM and compressed audio
Sample rate = 48kHz (SDI compliant)
Channels = 16 inputs and 16 outputs (4 groups of 4 channels each)
Delay = Embedder audio delay selectable 0 ... 320ms per channel
Metadata (RDD6)
1 channel input, 1 channel output, SDID selectable
BNC Input
Impedance = 75Ohm
Return loss = >15dB 5 ... 1485MHz; >10dB 1485 ... 2970MHz
Maximum cable length = 250m (SD), 230m (HD), 140m (3G) using Belden 1694A cable
Jitter tolerance = >0.7UI (alignment)
BNC Output
Impedance = 75Ohm
Output voltage = 0.8Vpp (typical)
Return loss = >15dB 5 ... 1485MHz; >10dB 1485 - 2970MHz
Output jitter = <0.2UI (alignment), <0.5UI (timing)
Latency
Video latency input to output = 120 ... 200 pixel, depending on video standard
Audio latency input to output, embedder and de-embedder combined = <0.6ms (HD, 3G), <2ms (SD)
General Features
Power fail relay bypass (may be enabled/disabled via GUI)
Lip-sync compensation for processed and non-processed audio signals
Dedicated routing for non-processed channels; all channels (maximum 16) can be routed to/from the device or looped through
Test pattern generator (no genlock)
Master-sync capable
ITU-R BT.1685 / ARIB STD-B39 metadata support
SDI Card Self-Test
The SDI card provides a built-in self-test for verifying the SDI signal path in all three supported physical signal formats: SD, HD, and 3G.
The exact video resolution or frame rate is not important for this test. One valid signal format from each of the three categories is sufficient.
Test Setup
Running the Test
Perform the test once for each of the following signal formats:
For each format:
Each individual test takes approximately 30 seconds.
Note - The exact video resolution or frame rate does not matter. The self-test only requires one successful test in each physical SDI format: SD, HD, and 3G.
If a test does not complete successfully, it is automatically restarted and continues to run until the test passes.
LED Indication
Important - Do not proceed to the next signal format until the current test has completed successfully and the LED indication has stabilized.